for children's recreation rooms) still include wood, especially medium-density fibreboard and plywood, as well as plastics and other synthetic materials under various trade names.īilliard cloth (sometimes erroneously called felt) is a specific type of cloth that covers the top of the table's "playing area". Today, inexpensive but not very rigid or durable materials used for the beds of low-end tables (e.g. The early table beds were made of cloth-covered wooden boards. Tables for the home market usually use slate beds as well, but the slate is often thinner, down to about 1⁄ 2 inch (13 mm). When several pieces of slate are joined poorly it is possible for the resin to deform and cause an uneven playing surface it can also be difficult to move once joined. The gap between slates is filled with a hard-drying putty, epoxy or resin, then sanded to produce a seamless surface, before being covered with the cloth. Small pool tables may use only one or two pieces of slate, while carom, English billiards and tournament-size pool tables use three. The bed – the cloth-covered horizontal playing surface – is, on good-quality equipment, made of solid, finely ground slabs of slate, most often from Italy, Brazil or China. This is mostly because snooker uses balls of a smaller diameter and smaller pocket entrances than pool does. įinally, snooker tables may use an L-shaped profile, such as the L77 profile. K-55 cushions have cloth, usually canvas, vulcanized into the top of the rubber to adjust rebound accuracy and speed. On a carom table, the K-55 profile is used (with a somewhat sharper angle than pool cushions). This causes the balls' rebound to be somewhat predictable during game play. The standard on American pool tables is the K-66 profile, which as defined by the BCA has a base of 1 3⁄ 16 inches and a nose height of 1 inch. The profile of the rail cushion, which is the cushion's angle in relation to the bed of the table, varies between table types. When installed properly the distance from the nose of the cushion to the covered slate surface is 1 7⁄ 16" while using a regulation 2 1⁄ 4" ball set. The purpose of the cushion rubber is to cause the billiard balls to rebound off the rubber while minimizing the loss of kinetic energy. The chiefly American jargon "rails" more properly applies to the wooded outer segments of the table to which the cushions are affixed. The cushions are made from an elastic material such as vulcanized (gum or synthetic) rubber. There are several different materials and design philosophies associated with cushion rubber. (August 2007)Ĭushions (also sometimes called "rail cushions", "cushion rubber", or rarely "bumpers") are located on the inner sides of a table's wooden rails. This section needs expansion with: subsections on rails, frame, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |